(2019). What's the latest on sub-$100 FPGAs this decade, anything significantly better than the Mojo I picked up back in 2013 to tinker with?
paaloeye 1 hours ago [-]
Outside of hello worlds, I’m always struggling to find a use case for such small boards. Any ideas?
gregsadetsky 37 minutes ago [-]
I've started to dabble in this only very recently. I have two iCEBreaker boards [0] in the mail right now that I'm excited for.
From what I understand, one of the big advantages of the up5k chip (the same chip on the webfpga and the icebreaker) is that there's an open toolchain that runs in seconds (at this chip size), which is not the case in the closed/Vivado/"typical fpga" part of the world. (feel free to correct me)
Purely in simulation this week, I had Claude (Fable) design a working Tetris out of 1400 relays - originally, this was for a Minivac web simulator that I/Fable had built [1]. Then, it compiled the relay netlist to Verilog and ran it on the simulated chip, comparing this (bezerk) port relay-for-relay against the original simulator. All matching (total llm time: less than an hour). I had it also make a viz of the netlist blinking through one simulated run [2] - sort of like visual6502.org..!
Today, I (Fable) ported tinystories [3], a very small language model to this exact same chip. It's currently "golfing" to get it to fit onto the real, not simulated chip (it's ~10% over, I'm hopeful). EDIT: it just golfed it.
None of these are "use cases", but these boards seem small/cheap enough that you can do new deranged things with them, which is very very exciting to me. I see a great future.
From what I understand, one of the big advantages of the up5k chip (the same chip on the webfpga and the icebreaker) is that there's an open toolchain that runs in seconds (at this chip size), which is not the case in the closed/Vivado/"typical fpga" part of the world. (feel free to correct me)
Purely in simulation this week, I had Claude (Fable) design a working Tetris out of 1400 relays - originally, this was for a Minivac web simulator that I/Fable had built [1]. Then, it compiled the relay netlist to Verilog and ran it on the simulated chip, comparing this (bezerk) port relay-for-relay against the original simulator. All matching (total llm time: less than an hour). I had it also make a viz of the netlist blinking through one simulated run [2] - sort of like visual6502.org..!
Today, I (Fable) ported tinystories [3], a very small language model to this exact same chip. It's currently "golfing" to get it to fit onto the real, not simulated chip (it's ~10% over, I'm hopeful). EDIT: it just golfed it.
None of these are "use cases", but these boards seem small/cheap enough that you can do new deranged things with them, which is very very exciting to me. I see a great future.
[0] https://1bitsquared.com/products/icebreaker
[1] https://minivac.greg.technology/tetris/
[2] https://necessary-doom-48128.ondis.co/
[3] https://arxiv.org/abs/2305.07759
* replacements for the C64 PLA, CIA, and potentially the SID
* Glue logic for a bread board project where it would require a lot of 74 or 4k series logic
* Translating TTL to VGA etc.
These are things people have used FPGAs for quite commonly
https://a.co/d/05f9gq9A
“KooingTech 150MHZ Machine Pulse Chip Mode Chip ACE V3 for X360 Slim”